Bill Being Repaired

I bumped into an Atlanta Gas Light truck and bent the fender, killed the header  panel and tore the bumper cover.

Yea, I was very mad! It was entirely my fault though and all I can do is get over it and go on.

I got a NOS fender off of Ebay from Dennis Carpenter and I am very pleased!!!!! They actually packed the part correctly and it got here without getting bent!!!! I also got a used bumper cover and header panel from Chuck Lambert's Ebay They were also very good to deal with!!

This is a header panel I already had that had a lot of wear on it from a Car BRA that I painted with "Duplicolor" spray paint and clear coat. (The color is a bit off)

I used the old torn bumper cover temporarily too.

I painted the bottom and edges of the fender so I could go ahead and install it.

So, now I wait till I c an afford the real paint job and will have the replacement header and bumper cover installed.

I still have to get the lettering on the fender and the hand drawn pin striping on the header panel done, then Bill if FINISHED!